
U-Line Ice Maker · Crystal City & Pentagon City
U-Line Ice Maker Repair in Crystal City & Pentagon City
In-home U-Line ice maker diagnosis and repair in Crystal City & Pentagon City, Arlington, VA. Same-day visits when the schedule allows.
Or book online and we'll get back to you to set a visit window.
Schedule Your Repair
Four quick steps. We'll confirm a visit window with you, and you'll get a written estimate before any work starts.
Service Type
What type of service do you need?
Or call us directly:
(703) 956-1511Repair Planned Around How Homes Here Are Built
If your U-Line ice maker has stopped doing its job, we can come out to your home in Crystal City & Pentagon City, find the fault and fix it on site whenever the part is in hand. Nearly every building here wants a service-elevator reservation and a sign-in at the desk, so check with management before your appointment. Nothing is repaired until you've approved a written estimate, and the work is covered by a 90-day parts and 30-day labor warranty.
How It Works
Related Services
Washington, DC · Arlington · Alexandria
Ready to schedule your repair?
WDC ProFix Repair: independent, in-home appliance repair with a written estimate before any work starts.
What Crystal City & Pentagon City does to a ice maker
Arlington's tap water comes from the Potomac through the Washington Aqueduct and is moderately hard, and over a few years the scale it leaves in the inlet valve and fill tube slows an ice maker down. Changing the filter on schedule helps more than most owners expect.
Problems worth ruling out first on a ice maker in Crystal City & Pentagon City:
- Leaking Water
- Water Leaking from Ice Maker
- Drain Pump Failure
- Condenser Dirty Reducing Efficiency
- Condensate Drain Clogged
- Overfilling with Ice
Known weak spots on U-Line ice makers
- Slab not cutting into cubes
- Very little ice
- Water pooling under the machine
- Drain pump not running
Look first at scale on the evaporator plate, cutter grid that no longer heats, drain pump failure, and inlet valve restricted by scale, since that is where U-Line ice makers tend to fail. Calls about them usually mention slab not cutting into cubes, very little ice, and water pooling under the machine. If ice comes slowly or drops as one sheet, run a cleaning cycle first; mineral buildup or a dead cutter grid is the likely cause. Dropping ice production is nearly always scale or a starved water supply rather than a broken component.
Read the full U-Line ice maker repair guide, with common questions →