Basement water is a familiar problem in parts of Washington. Older neighborhoods are on a combined sewer system, and a heavy downpour can overwhelm it and push water back into low drains. Bloomingdale and LeDroit Park saw repeated backups in the summer of 2012, and the flash flood of July 8, 2019 put water into streets and basements across the city. The Northeast Boundary Tunnel, part of DC Water's Clean Rivers Project, now takes pressure off that system. Water still finds basements, though, through storms, dead sump pumps, burst pipes and leaking water heaters. Across the river, the low blocks of Old Town Alexandria near the waterfront also take on water in heavy rain and high tides, and the same steps apply there.
The machines that live in basements, such as washers, dryers, chest freezers, second refrigerators and often the water heater and furnace, are the ones most exposed. This checklist is about staying safe and deciding what can be restarted.
First: Your Safety
- Do not walk into standing water if outlets, cords or appliances are submerged or the water might reach them. Ready.gov's flood guidance warns against touching wet electrical equipment or standing in water around it.
- Cut the power only when nobody is put at risk reaching the breaker. A panel sitting in a flooded basement stays off-limits; contact Pepco or an electrician instead of stepping into the water.
- If you smell gas, leave. Do not flip switches. Phone Washington Gas or 911 only after you are out of the house.
- Treat sewer water as contaminated. Wear boots and gloves, and keep children and pets away.
- For a sewer backup, DC Water's sewer backup page explains how to report it and who is generally responsible for cleanup.
Document Before You Clean
- Photograph the water line on walls and appliances before it recedes or before cleanup starts.
- Photograph model and serial labels on each affected appliance.
- Note the date, time and source of the water if you know it.
- Keep receipts for any cleanup or replacement. Insurance and any claim process will ask for them.
In an English basement rental, both the tenant and the owner should be told right away. Fixing or replacing a flooded appliance that came with the unit is usually the owner's job, not the renter's.
Washer and Dryer
Laundry machines often sit on the basement floor, so even a few inches of water reaches the motor, pump, wiring and controls.
- Leave them unplugged until they are fully dry and inspected. Do not test them by turning them on.
- Gas dryers that took on water need the burner, gas valve and controls checked before use. Leave the gas shutoff closed in the meantime.
- Wipe and dry the exterior, but do not open control panels yourself.
- Check the dryer vent. A duct that sat in water may be packed with debris or crushed.
- Clean the washer after a sewer backup. Even if it works, the drum, hoses and pump may need disinfecting, and a technician can tell you whether parts should be replaced.
Refrigerators and Freezers
- A fridge or freezer whose compressor area was submerged should stay unplugged until inspected.
- The FDA's guidance on food and water after floods says not to eat any food that may have touched flood water, and to discard food in containers that are not waterproof if flood water may have reached it.
- The FDA's figures, assuming the doors stay closed: about 4 hours of cold for the refrigerator, approximately 48 hours for a full freezer, and roughly 24 for one that is half full. The FDA advises throwing out refrigerated perishable food that sat above 40°F for 4 hours or longer.
- Clean and sanitize the interior before restarting any unit that will be kept.
Kitchens in English Basement Units
An English basement apartment often has a full kitchen a few steps below grade, which puts the dishwasher, range and refrigerator in the path of floodwater. A dishwasher keeps its pump, motor and wiring at the bottom of the tub, right at the waterline. Electric ranges have wiring and terminal blocks low on the back. Keep all of them off until they have been dried and inspected, and treat a gas range like any other gas appliance that took on water.
Water Heater, Furnace and Other Gas Equipment
These are outside what an appliance repair company handles, but they matter for the whole basement. Any gas water heater or furnace that took on water should be inspected by a qualified professional before being relit. Watch for carbon monoxide risks once equipment is back on, and keep a working CO alarm in place.
Restarting: A Short Order of Steps
- Water removed and the floor dry.
- Electrical panel and outlets cleared by an electrician if they were wet.
- Each appliance dried, cleaned and inspected.
- Gas appliances checked before the gas is reopened to them.
- Appliances restarted one at a time, watching for tripped breakers, smells or noises.
Reducing the Next Flood's Damage
- Raise the washer, dryer and chest freezer on sturdy platforms.
- Keep floor drains clear and do not stack storage on them.
- A plumber can tell you whether your sewer lateral is a good candidate for a backwater valve, a common upgrade in combined-sewer neighborhoods.
- Add inexpensive water sensors near the machines.
- Check your insurance for sewer backup coverage, which is often separate.
Getting the Appliances Checked
WDC ProFix inspects washers, dryers, refrigerators and freezers after basement water, including in rowhouse basements around Shaw and Bloomingdale. A technician checks what was exposed, tells you what can be saved, and writes up the cost before any work. See our washer repair page, read our storm outage checklist, or book online.
