Call Now

Range · Checklist

Inspecting a Pre-Owned Range for a DC Kitchen, Gas or Electric

Buying a used gas or electric range for a DC rowhouse or condo kitchen? Test burners, oven heat, door and controls, then confirm the hookup and fit at home.

By WDC ProFix Service Team4 min read

Ranges are among the sturdier appliances in a kitchen, which is why so many of them get resold. A secondhand range can be a good fit for a rowhouse kitchen that has room for exactly one standard-width unit, or for a condo where the old range finally quit. The catch is that a range combines heat, fuel and electricity in one box, so a careful look before you buy is worth more here than with most appliances.

Ask the seller to keep it connected so you can see it work. A range that has been unhooked and stored is hard to judge, and testing a gas range yourself without a proper connection is not safe.

Identify the Range

  • Find the rating plate. On many ranges it is behind the storage drawer, on the oven frame inside the door, or on the back. Photograph the model and serial number.
  • Check the model on CPSC's recall site.
  • Confirm the fuel. Gas, electric and dual-fuel ranges need different hookups, and you need to know which one your kitchen has.
  • For a gas range, ask whether it has been converted to propane at any point. A range set up for propane must be converted back for natural gas by a qualified installer.
  • Look up the manual by model number so you know the controls and any self-clean instructions.

Gas Range: What to Watch

  • Burner ignition. Each burner should click and light within a few seconds. Constant clicking after the flame is lit, or a burner that will not light at all, can mean a dirty or failing igniter or a misaligned burner cap.
  • Flame color. Look for a steady blue flame with even height all the way around. Large yellow or orange flames, or flames that lift away from the burner, suggest the burner needs cleaning or adjustment.
  • Oven ignition. Set the oven to bake and wait. Many gas ovens use a glowing igniter that takes a minute or so before the burner lights. If it glows but never lights, the igniter may be weak.
  • Odor. A faint smell on startup can happen, but a persistent gas smell is a reason to stop. At home, a gas smell is a cue to exit right away; skip the light switches and do not make the call indoors. Contact Washington Gas or dial 911 after you are out.
  • Knobs. Make sure each knob must be pushed in before it turns, and that none spin freely.

Electric Range: What to Watch

  • Coil elements should glow evenly. Cracks, blisters or an element that heats only part way point to replacement.
  • Glass and ceramic tops should have no cracks or chips. A crack in the glass is a reason to stop using the cooktop.
  • Each control should change the heat smoothly from low to high.
  • The bake and broil elements in the oven should both heat. Look for spots or breaks on them.

Oven Checks for Both Types

  1. Bring an oven thermometer. Preheat to 350°F, then compare the setting with the reading from a thermometer placed mid-oven. A big gap from the setting points to a sensor, thermostat or igniter issue.
  2. Look at the door gasket for tears and gaps. Heat escaping from the top of the door often means a worn seal.
  3. Open and close the door several times. It should hold partly open and close firmly. A door that drops open can mean broken hinges or springs.
  4. Check the oven light, clock, timer and any error codes on the display.
  5. Ask whether the self-clean cycle has been used and whether it worked. Self-clean runs very hot and sometimes exposes weak parts.
  6. Look inside for heavy carbon buildup or rust, and check the storage or warming drawer slides.

Fit, Hookup and Safety at Home

A working range is only a good buy if it fits your kitchen and your utility connections.

  • Width and depth. Measure the opening, then the range including handles and knobs. Many DC rowhouse and condo kitchens were built around a standard width, but some compact kitchens use smaller units.
  • Gas supply. Confirm a gas line with an accessible shutoff valve. Use a new approved flexible connector rather than the old one, and have the connection done and leak-checked by a qualified professional.
  • Electric supply. An electric range needs a dedicated high-voltage circuit and a matching outlet and cord. Gas ranges still need a standard outlet for igniters and controls.
  • Anti-tip bracket. Install one. Skip the bracket and a range can topple toward you when weight lands on the open oven door.
  • Ventilation. Check the hood or fan above the range. Gas cooking adds combustion byproducts to kitchen air, and a working hood that vents outside helps.
  • Carbon monoxide alarm. Any home with gas appliances should have one. Our carbon monoxide checklist explains where alarms belong.
  • Getting it inside. Measure doors and stairs on the way, and check any building rules for elevator reservations or delivery times.

When a Technician Should Take a Look

If the range came home and the oven will not hold temperature, a burner will not light, the display shows error codes, or there is any doubt about the gas connection, have it checked before relying on it for daily cooking. WDC ProFix services gas and electric ranges throughout the District, from rowhouse kitchens to tower condos. See our range repair and oven repair pages, or book online.

Checklist Done and Still Stuck?

In-home appliance repair across Washington, DC · Written estimate before any work starts · 90-day parts & 30-day labor warranty

More From Our Blog

CallBook