
Amana · Washer
Amana Washer Repair in Washington, DC
Amana washer repair in your DC home or condo. Same-day visits when the schedule allows.
Or book online and we'll get back to you to set a visit window.
Schedule Your Repair
Four quick steps. We'll confirm a visit window with you, and you'll get a written estimate before any work starts.
Service Type
What type of service do you need?
Or call us directly:
(703) 956-1511Repair Planned Around How Homes Here Are Built
WDC ProFix Repair fixes Amana washers in rowhouses, condos and detached homes across Washington, DC. The faults below are the ones Amana washers are known for, and they're where the diagnosis starts. We're an independent repair company: if your washer is still under Amana's warranty, contact Amana first. Otherwise you get a written estimate before any work starts, and repairs carry a 90-day parts and 30-day labor warranty.
How It Works
Washington, DC · Arlington · Alexandria
Ready to schedule your repair?
WDC ProFix Repair: independent, in-home appliance repair with a written estimate before any work starts.
Amana washer repair: what to know
The lineup in brief: Amana washers are mainly agitator top-loaders with a short list of cycles, plus a few front-load models.
Usually the problem with an Amana washer is failed lid switches, broken motor couplers, drain pumps jammed by debris, or water inlet valves. Owners tend to describe it in words like these: no spin, water not draining, and agitator not moving. If the tub fills and agitates but will not spin, press on the lid strike with the lid up; when nothing happens, the lid switch is a likely suspect. A washer that refuses to start or spin with the door closed typically has a failed door lock or lid switch.
Lid switches and drive couplers are the usual failures on agitator top-loaders, and both are inexpensive. A machine that drains slowly may have a sock or coin in the pump rather than a dead pump. With cheap parts everywhere, an Amana washer is normally a good repair candidate.
Rowhouse condo conversions often tuck a stacked washer and dryer into an upstairs closet, so a weeping hose or door boot shows up on the ceiling of the unit below. Part of the first visit is separating install problems, like a drain hose at the wrong height or an unlevel machine, from parts that have really failed.
An Amana top-loader that fills with water but will not agitate usually has a failed lid switch or worn agitator dogs. Even something routine like the drain pumps jammed by debris is quoted in writing first, and once finished it falls under our 90-day parts, 30-day labor coverage.
Replace plain rubber fill hoses with braided stainless ones and renew them every few years. When the problem is tub filling slowly, a quick video of it helps the technician arrive ready.
Known weak spots on Amana washers
- No spin
- Water not draining
- Agitator not moving
- Tub filling slowly
Still have questions?
Call or book online and ask us directly. We'll give you a straight answer.