Call Now

Ice Maker Repair in Deanwood & Benning

Ice Maker repair in Deanwood & Benning: we come to you, find the fault and explain the fix before any work starts. Same-day visits are possible when the schedule allows.

$150–$320
Typical repair range
1–2 hours
Typical repair time
Written
Estimate before work
90-day
Parts warranty

Schedule Your Repair

Four quick steps. We'll confirm a visit window with you, and you'll get a written estimate before any work starts.

1
2
3
4

Service Type

What type of service do you need?

Or call us directly:

(703) 956-1511

Before you call: ice maker trouble in Deanwood & Benning

DC's tap water comes from the Potomac and is moderately hard, and over a few years the scale it leaves in the inlet valve and fill tube slows an ice maker down. A unit in a cold garage or porch can also freeze its fill tube in winter.

Many detached homes here have a yard and driveway, so access is easier than in a rowhouse; mention it if the laundry is in the basement.

  • Freezing Section Not Cold Enough
  • Overfilling with Ice
  • Water Leaking from Ice Maker
  • Water Inlet Valve Failure
  • Scale Buildup in Water Lines
  • Water Pump Failure
  • Scale Buildup on Evaporator Plate
  • Water Flowing Constantly into Ice Maker

ZIP code covered in Deanwood & Benning

Select a ZIP code for local details.

Deanwood & Benning Service Area — 1 ZIP code

Ice Maker brands we repair in Deanwood & Benning

Choose your brand for its known faults and repair details.

Sub-Zero ice maker repair in Deanwood & BenningAtosa ice maker repair in Deanwood & BenningHoshizaki ice maker repair in Deanwood & BenningTraulsen ice maker repair in Deanwood & BenningManitowoc ice maker repair in Deanwood & BenningMaxxIce ice maker repair in Deanwood & BenningPerlick ice maker repair in Deanwood & BenningScotsman ice maker repair in Deanwood & BenningU-Line ice maker repair in Deanwood & Benning

What to Try Yourself, and What to Leave Alone

Confirm the ice maker switch or the control setting is on and that the bin is seated so the sensor sees it. Check that the household supply valve behind the fridge or under the sink is fully open. If you recently changed the filter, reseat it and run a few glasses through the dispenser to purge air. Look at the fill tube where it enters the mold; if it is capped with ice, a hair dryer on low held at a distance can clear it, with the fridge unplugged.

Empty a bin that has clumped and discard the old ice. Wipe the bin and let the module start fresh. On an undercounter machine, run the cleaning cycle with the descaler the manufacturer specifies and check that the drain is not kinked.

Leave the inlet valve, the module wiring and any refrigeration work alone. The valve runs on household voltage and sits close to water. Also resist the urge to force the ejector arm or pry cubes out of the mold with metal tools; the mold has a nonstick coating and an embedded heater that are easy to damage. If the module was switched off for a vacation, give it a full day after switching it back on before deciding it has failed, since the first harvest can take several hours.

FAQ

Ice Maker questions

Can't find your answer? Book a service call or call us now.

Still have questions?

Call or book online and ask us directly. We'll give you a straight answer.

Book ice maker repair in Deanwood & Benning

Nothing is repaired until you've approved a written estimate, and the work is covered by a 90-day parts and 30-day labor warranty.

CallBook